Atari Games Area 51 — Atari Games Area 51 Arcade Machine Operator's Manual PDF

CHAPTER 2 — SELF-TEST 4 AREA 51 OPERATOR'S MANUAL Each gun is calibrated separately. Hold one gun at a normal playing distance from the screen. Use the sights to aim the gun at the cross hairs on the screen. Press and hold the trigger until the screen stops flashing and the word “DONE” appears (in the same color as the gun that you are calibrating). The gun is now calibrated. Repeat the process with the other gun. MEMORY TESTS COLOR RAM WORKING RAM rE LS CET Lar Re ie] ys Use the tracking screen to verify that the gun tracks evenly across the entire screen (with the exception of the edges, which are used as a buffer zone). Exit to the main menu to save the calibration settings.

To select test, use GUN To run test, Press right START Bee Disk Test Figure 2-10 Use the Disk Test the hard disk. screen, shown in Figure cure. The test will continue running until the left start button is pressed. Normally, the “Status” of the drive will display as “Good”. If the “Status” displays “Bad”, check the cables going to the drive, then run the test again. QUANTUM ty, and convergence. Advance to each screen to completely test the monitor.

MONITOR TESTS a OxFFEQ0000 OxFFOA7610 COLOR BARS CONVERGENCE FIREBALL 1080A ae Head i) Peta me ele) 1265 CCToreTe| Memory Tests Screen The monitor test selection screen (shown in Figure 2-11) lets you select from three screens — color, puri- Yes BIR eee La Monitor Tests DISK TEST Device Pointer: Sector Pointer: me 2-9, to test If the “Hard Drive Connected:” display shows “No’, check that all of the cables going to the drive are se- Hard Drive Connected:

mem PURITY ee ee Stacie rag 3999 kb/s Bricweslils) accel it) Area51 1.0 October 31,1995 To select test, use GUN ROR Chime tl eae Nad Beek Mut Mette eee To return to menu, Press left START Figure 2-9 Disk Test Screen Memory Tests Use this selection screen, shown in Figure 2-10, to run a memory test. These tests check the RAM and ROM chips. When the game power is turned on, the computer automatically runs through the random-access memory (RAM) tests. To bypass the startup RAM test, tap the right start button repeatedly. 2-6 Ca ww Figure 2-11 Monitor Tests Screen Color Test The color test (see Figure 2-12) indicates the dynamic range of the video display color circuitry.

The screen should show four bands (red, green, blue and white), ranging from dark to bright, from left to right. The red, green, and blue bands are produced by only one color gun being turned on in each band.