omron — Creating an Example User Interface

Creating an Example User Interface The completed Connection and Power group should look similar to the following figure. Connection and Power Group Box with Tools 6. Add the following tools to the "Process Control" group, and then use the properties to format and connect them to the corresponding data items, as shown in the table. ACE User's Guide, 3.6.x 18316-000 Rev A Page 1078 Tool Appearance Images Property Links Selection check box Text: Power / Cal ItemValue: Controller > General > Power and Calibration ValueWhenUnchecked: 0 ValueWhenChecked: -1 Toggle Button DisplayMode: DigitalInput ItemValue: Controller > General > Power and Calibration ValueWhenUnpressed: 0 ValueWhenPressed:

-1 Label Text: Power / Cal Status Tool Appearance Behavior Property Links Selection Check Box Text: Part 1 Pro- cess ItemValue: Process Manager > General > Pro- cess 0 Enabled Button Text: Start ItemValue: Process Manager > General > Run Status ValueWhenPressed: -1 Button Text: Stop ItemValue: Process Manager > General > Run Status ValueWhenPressed: 0 Label Text: Monitor Speed