Using a Command Line to Deploy the UI 6. Click Save . The shortcut is saved to the specified location. Using a Command Line to Deploy the UI Option 1: Starting the ACE Client, Server and UI Separately To start the client and server separately: 1. Start the ACE server. a. Start ACE in server mode (or service) with the workspace loaded. This can be done by check- ing the “Load Workspace at Startup” option, or using the datafile command-line parameter. NOTE: When using the datafile command-line parameter, you must include the path to the file location on the system hard drive. For example the following command, which is entered at the Windows command prompt, will load the specified workspace:
ace.exe server datafile="[path to file]XXX.awp" -OR- b. Start ACE through the “ACE” Windows desktop shortcut and have the "Load Workspace at Startup" option enabled. This will start the standard ACE client and server, and load the spe- cified workspace. 2. Use the "loadui" startup parameter to start an ACE client that will launch the specified user inter- face. From the Windows command prompt, change to the ACE\bin directory and then enter the com- mand: ace.exe client loadui="/User Interface Form" Option 2: Start the ACE Software and UI Simultaneously To start the user interface and server simultaneously (in one call):
Use the “Load workspace at startup” option, or the datafile command line parameter, to load the Work- space. NOTE: When using the datafile command-line parameter, you must include the path to the file location on the system hard drive. For example the following command, which is entered at the Windows command prompt, will load the spe- cified workspace and then initialize the specified user interface: ace.exe client_server datafile="[path to file]XXX.awp" loadui="/User Interface Form" If you are using the "Load Workspace at Startup" option, you can omit the "datafile..." parameter from the above command string. ACE User's Guide, 3.6.x 18316-000 Rev A Page 1084