Camera Trigger Mode Camera Trigger Mode If the camera is in Trigger mode, the Trigger Period must be set (in Control Sources), as shown in the fol- lowing figure. Camera Trigger Period in Emulation Mode The Trigger Period in Emulation Mode setting is displayed only when the ACE software is in emulation mode. For more details on control sources, see Control Sources on page 869. Latch Period (Distance) For part or part target instances that use Latch mode, the latch period (distance) must be set in the Belt object editor, as shown in the following figure.
Latch Period Setting (in Belt Object Editor) The Latch Period in Emulation Mode setting is displayed only when the ACE software is in emulation mode. For more details on the Belt object editor, see Belt on page 809. Virtual Camera Emulation Configuration (Behavior) If vision is used, the virtual camera emulation configuration (behavior) must be set, as shown in the fol- lowing figure. ACE User's Guide, 3.6.x 18316-000 Rev A Page 1102