Adept AnyFeeder Object Object Menu Help Displays the online help for the AnyFeeder object. Refresh Editor Refreshes the contents of the AnyFeeder object. Close Closes the AnyFeeder object. Status Group The Status group provides operation and error information on the AnyFeeder object. The current status is shown in the top field; a description of the status is shown in the lower field. Configuration Page The Configuration Controls page (shown in the previous figure) provides a set of Adept AnyFeeder con- figuration controls. The following table describes the function of each control.
ACE User's Guide, 3.6.x 18316-000 Rev A Page 140 Item Description Communication The Communication group is used to set the com- munication parameters for the AnyFeeder. COM Port Specifies the COM (serial) port that is used to send com- mands to the AnyFeeder. Firmware Version The firmware version as returned from the feeder ACE Sight Configuration This is an identifier used to allow driving the AnyFeeder dir- ectly from V+ using commands like VPARAMETER, VRUN, etc. For more details, see the Adept AnyFeeder User's Guide. ACE Sight Index There is an index to identify an ACE Sight sequence, this is the corresponding identifier for the AnyFeeder.
Specify a unique value for the AnyFeeder—it must be different than that used for the ACE Sight sequence, NOTE: When an AnyFeeder and an ACE Sight sequence have the same index value, the PC will only try to run the ACE Sight sequence. 3D Display Provides controls for showing the AnyFeeder object in the 3D Visualization window, and for adjusting the position of the AnyFeeder in the workcell.