FlexiBowl Feeder Object Closes the AnyFeeder object. Configuration Page The Configuration Controls page (shown in the previous figure) provides a set of configuration controls. The following table describes the function of each control. Standard Controls Page The standard controls page provides a set of commonly-used controls for adjusting the feeder. ACE User's Guide, 3.6.x 18316-000 Rev A Page 146 Item Description 3D Visualization: Model and Visible Identifies if the feeder is displayed in the 3D virtual display and the model number of the feeder to render. Configuration: Address The IP Address of the FlexiBowl feeder Configuration:
ACE Sight Index There is an index to identify an ACE Sight sequence, this is the corresponding identifier for the feeder. Specify a unique value for the feeder—it must be different than that used for the ACE Sight sequence, Location: Offset from Parent and Par- ent The position of the FlexiBowl feeder relative to a parent in the workspace.