DeviceNet Scan DeviceNet Scan NOTE: When emulation mode is enabled, this item is not available. For more details on emulation mode, see Emulation Mode on page 1089. The DeviceNet scanner, shown in the following figure, allows you to scan for DeviceNet nodes and view information about them (product name, input size, output size, product id, status, etc). The DeviceNet scanner is accessed from the Configure button on the Controller Editor object. For more details, see Con- troller Editor on page 97. DeviceNet Scanner When using the DeviceNet scanner to scan for DeviceNet nodes on your system: l Use the Baud Rate drop-down list box to set the desired baud rate for your system.
This must be set to the same value as defined in the DeviceNet area on the Configuration tab (described earlier in this topic). l Use the Local MAC ID drop-down list box to set the MAC ID for your system. This must be set to the same value as defined in the DeviceNet area on the Configuration tab (described earlier in this topic). l Click Scan to initiate the scanning process. If there is no LOCAL statement, you are prompted to add one before scanning, as follows: ACE User's Guide, 3.6.x, 18316-000 Rev A Page 193