Load Configuration Data from a File Load Configuration Data from a File Use this option to: l Restore configuration data for the current robot from a backup file created using the Save Con- l Copy the configuration data from another robot to the currently selected robot. figuration option. After you have loaded a configuration file, use the Apply button to write the changes to the controller. To load configuration parameters from a file: 1. From the Configuration Manager menu, select File > Load configuration (or use shortcut: Ctrl+O) to display the file selection dialog. 2. Choose the desired .cfg file, then click OK . The configuration file information dialog is displayed:
Configuration File information Dialog 3. Click Continue to load the file. The values in the configuration file will be loaded into the Con- figuration Manager. 4. After the file is loaded, use the Apply option to save the changes to the controller. If you don't have full access to modify the configuration parameters, the Configuration Manager Utility generates a Load-File Report listing the values that were not loaded. For details on access levels, see Change Access Level on page 275. ACE User's Guide, 3.6.x 18316-000 Rev A Page 290