Edge Locator Setting the Position Constraint Function Editor Score Threshold The score threshold sets the minimum acceptable score for a valid edge. The tool will disregard edges that obtain a score lower than the Score Threshold. l Scores attributed for constraints range from 0 to 1. l If both Position and Magnitude constraints are enabled, each constraint accounts for 50% of the total edge score. Sort Results You can enable the Sort Results checkbox to sort the located edges in des- cending order based on values. By default, Sort Results is not enabled and edges are output in the same left to right order as they appear on the pro- jection curve.
Region of Interest (ROI) The region of interest is the area in which the tool carries out its process. Most tool position parameters can be set through the region of interest section of the tool interface. The fol- lowing parameters define the tool region of interest. Offset Offset is the center of the ROI, defined by: ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 477 X X coordinate of the center of the region of interest