ACE Sight Camera Calibration l Take a Picture of the Calibration Target Located Calibration Target 1. Adjust the bounding box to the work area. This must include the calibration tar- get, as shown in the previous figure. 2. If no magenta origin marker is displayed, click Run. If necessary, move the target so it can be located, then click Run. 3. Click Next. l Define Calibration Point 1. Move the robot to the target. Click Pendant to display the Pendant window. This enables you to move the robot, so that the end-effector is centered over the target. 2. Click Here. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 680