omron — ACE Sight Camera Calibration

ACE Sight Camera Calibration Vision Model After Teaching 1. Move the robot so that the model is near the center of the camera field of view. 2. Click Run to take an image. 3. Adjust the model bounding box to fully enclose the model. Make it close to the perimeter of the model, as shown in the previous figure. 4. Move the origin marker to the center of the model. l Drag the origin marker to the center of the model with the mouse or l Click Edit o Click Center to center the marker on the bounding box or o Click on the outline of the model, then click Center to center the marker on the found part The Edit window is shown in the following figure. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 694