omron — ACE Sight Camera Calibration

ACE Sight Camera Calibration Edit Window l Locating the Target 1. Close the Pendant window, if open (click Cancel). 2. Click Run. The target should be marked with a magenta origin marker. If not, move the target, and click Run again. l Advance the Belt The robot should go to the target when you click Next. l Continue testing the calibration o I wish to continue testing l Move the robot to the location where the picture is taken l Locating the calibration target l Advance the belt ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 716