Setting the Part Buffer Access Order Part Buffers Added to the Processes Group 7. Set the part buffer access order, as described in the following section. Setting the Part Buffer Access Order When a pallet is used for the part buffer, you need to specify how the parts will be accessed as the buffer is being emptied. There are two choices: l First In, First Out (FIFO): The first part placed into the part buffer will be the first part removed. l Last In, First Out (LIFO): The last part placed into the part buffer will be the first part removed. NOTE: When parts are "stacked" (more than one layer is specified for the pallet), the access order must be set as LIFO.
To set the part buffer access order: 1. In the Control Sources group, click Edit . The Control Sources editor opens, as shown in the following figure. For details, see Control Sources on page 869. Control Sources Editor with Part Buffer Selected 2. In the Configurations group, click Static Source For /Part Buffer, as shown in the previous figure. 3. Optionally, select the desired Buffer Initialization Mode to indicate the state of the part buffer when ACE User's Guide, 3.6.x, 18316-000 Rev A Page 839