omron — Belt Calibrations

Belt Calibrations The bottom area of the Belt Calibration Editor displays a graphical representation of the belt parameters. You can use the "handles" (blue dots) to position the lines in the graphical window. As the lines are moved, the values for the editor parameters are updated. Belt Filters There are two areas of the Belt Calibration Editor parameters that control how parts are picked by the robot: the Downstream Pick Limit Line parameters and the Horizontal Filtering parameters.

For more details on filtering, see Process Strategies on page 878 Saving and Loading a Calibration After a calibration has been completed, the data can be saved by selecting File > Save To on the cal- ibration editor menu. You can load a previously-saved calibration file by selecting File > Load From on the calibration editor menu. Using the Calibration Wizard NOTE: This feature operates differently in emulation mode. For details on emulation mode wizards, see Emulation Mode Wizards on page 185. The Robot-to-Belt Calibration wizard provides an interactive series of steps that guide you through the cal- ibration process.

Each step of the wizard contains graphical aids and text that describe the particular step being performed. As each step of the wizard is completed, the information from that step is collected and used to populate the fields in the Belt Calibration Editor, which is described in the previous section. ACE User's Guide, 3.6.x 18316-000 Rev A Page 852 Item Description Downstream Limit Line The part positions will be compared against a line in the downstream part of the belt window (see the angled line in the previous figure). The parts closest to the line will be processed first.

The position and angle of the line are specified using the line angle (degrees) and line offset (mm from conveyor origin) settings. You can also set the angle and position of the filter by dragging the blue dots (handles) to the desired positions. Horizontal Filtering If this is enabled (True), the pick area is limited to a subset of the width of the belt window. You can force different robots to pick in different horizontal regions (lanes) of the belt.

For example, if you think of the conveyor belt as a three-lane highway (as shown in the previous figure), you may have robot 1 filtered to pick from the near one-third of the belt window, robot 2 filtered to pick from the middle one-third of the belt window, and robot 3 filtered to pick from the far one-third of the belt window. You can also set the angle and position of the filter by dragging the blue dots (handles) to the desired positions.