omron — Belt Calibrations

Belt Calibrations Belt Calibration Wizard (Test Calibration) NOTE: If the Robot Jog Control (Pendant) is open and is still in Manual (manual control) mode, the Wiz- ard will recognize this and change the mode to "COMP" (computer control) mode. Optionally, this page also allows you to remove the "yaw" (tilt) component from the belt transformation, as follows: l Click the Level Along arrow to level the belt transformation along the length of the conveyor. l Click the Level Lateral arrow to level the belt transformation along the width of the conveyor. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 855