Configuration Items a. Click Pendant to open the Robot Jog Control. b. Use the Robot Jog Control to position the robot tool tip at a point on the +X axis (in the case of a rectangular pallet, this can be any pocket position along the +X axis; however, optimum results will be obtained by using a point as far away from the origin as possible). c. Click Here to record the position. 3. Teach the +Y Location a. Click Pendant to open the Robot Jog Control. b.
Use the Robot Jog Control to position the robot tool tip at a point on the +Y axis (in the case of a rectangular pallet, this can be any pocket position along the +Y axis; however, optimum res- ults will be obtained by using a point as far away from the origin as possible) . c. Click Here to record the position. 4. Click Calculate to calculate the position of the robot frame relative to the robot. 5. Click OK to close the Robot Frame editor. Motion Sequence Grid Editor The Motion Sequence Grid Editor provides a spreadsheet-like (grid) interface that allows you to edit:
l Pick motion parameters l Place motion parameters l Vision refinement parameters l Offset location parameters To access the grid editor, click Grid in the Configuration Items group. The Motion Sequence Grid Editor opens. ACE User's Guide, 3.6.x 18316-000 Rev A Page 866