Processes ACE User's Guide, 3.6.x 18316-000 Rev A Page 886 Item Description turned off when the Process Manager stops the application. Speed Control If this is selected, you can use the Slow slide control to adjust the conveyor speed threshold. Otherwise, the conveyor belt operates at a constant speed. Robot Queue Specifies a robot for queue monitoring (the queue size for the robot is set in the Robot Parameters group) The selected robot will typically be the last robot in the chain of robots servicing a conveyor. If parts get to the last robot, it needs to slow/stop the conveyor to ensure all parts are processed.
Slow (slide control) Specifies the point in the belt window for slowing the conveyor if parts reach that point. This is useful for preventing the belt from feeding the robot faster than the robot can pick the parts. For example, 50% means that if a part reaches the mid- point of the belt window, the conveyor will be slowed. Off Threshold / On Threshold (slide control) Specifies the part threshold point in the pick window (from the Upstream Limit to the Pick Limit) for stopping the conveyor. For details on the belt limits, see Belt Cal- ibrations on page 848. This control is useful for preventing the belt from feeding the robot faster than the robot can pick the parts.
For example, if the off threshold is set to 90%, if a part reaches 10% from the end of the belt window, the conveyor will be turned off (assuming the Always On option is not selected). The setting will be higher than that used for the Slow threshold. When a belt is turned off by the Off Threshold, the belt will remain off until all instances are removed between the Off Threshold point and the On Threshold point. This can be used to minimize the number of times the belt is started and stopped. NOTE: The Always On option must be unchecked (not selected) for the Off Threshold setting to function.
If the Off Threshold point is beyond the pick line, then the robot will not be able to pick this part. For this reason, the stop line is displayed on the 3D Visualization of the belt window as a black line. Product Flow (arrow) Shows the product flow (belt window) direction of travel in relation to the Slow and Off Threshold slide controls. It is a reference for the thresholds. The bottom of the arrow represents the start of the belt window; the top of the arrow represents the end of the belt window. Processes This section describes the Processes group in the Process Manager.
The Processes group defines the elements (robot, pick location, place location) for a particular process that will be controlled by the Process Manager.