Static Pick and Place Sample Static Pick and Place Sample After you select the application sample, you are ready for the setup and programming of the application. An interview wizard guides you through the process, as described below. The following instructions are provided as an example of a Process Manager static pick and place applic- ation. The steps for your application sample may vary, depending on the application sample selected in the previous section. However, this example will provide an overview of the basic steps for programming an application sample. What happens next? You will use the interview wizard to:
l Select the robot The interview wizard will pause momentarily to create the objects and write the program code, then you will: l Select the gripper l Teach the process in the Process Manager. You will teach the Idle, Part (pick) and Part Target (place) positions. l Run the process using the Process Manager Control. To program the application: After you complete the introduction pages of the interview wizard, continue with the steps described below. ACE User's Guide, 3.6.x, 18316-000 Rev A Page 961