AutoVISION Quick Start Guide December 2020 5.9.3. Opening Telnet Client to view results Additional Information Reason to test using Telnet Client Quickly see the results that are output from your camera over a specific TCP/IP Socket and Port. If the Telnet Client has not been enabled in Windows, please go to the link below and follow the instructions to enable this Windows feature. https://social.technet.microsoft.com/wiki/contents/articles/38433.windows-10-enabling-telnet- client.aspx a. Click the Windows Start button, type cmd.exe and hit the Enter key. b. In the cmd.exe window type the following command listed. Replace the 192.168.188.2 (Default setting) with your camera IP address.
Precautions for Correct Use Using Emulator Your camera IP address can be found if you click on the word Connect in AutoVISION. If using the Emulator use IP address: 127.0.0.1 (Loop back address). Typical Example: Type telnet 192.168.188.2 49211 b c. Click the [Try Once] button in AutoVISION. Each time the Inspection is run the decoded text is shown in the Telnet window on a new line. c