Badlands Universal Kit Installation Grounding the Cabinet Find the ground lead (green) of the 115V input power line. Connect this lead in daisy-chain fashion to a bare metal part of the coin door, both pedals, the control panel, the video display, and the power supply. This is a safety requirement for the players’ protection. This AC ground must be of #18 AWG wire or larger. Checking the JAMMA Connections Before plugging in the game PCB, turn on the power to the game, and check +5 Volts on pins 3, 4, C, and D of the JAMMA connector; +12 Volts on pins F and 6; and -5 Volts on pins E and 5. Check that the video display and the attraction lamp have power. Now turn off the power to the game.
Installing the Badlands Printed-Circuit Board Perform the self-test when you first set up the game, each time you collect the money, or when you suspect game failure. Setting the Coin and Game Options The Badlands coin and game options are set in the self-test. See Chapter 2 for information about the option settings. Game Play This section of the manual describes the theme of the Badlands game and the game play features. Introduction 1. After you have checked the power on the JAMMA connector, above, install the Badlands game PCB in the cabinet. Use the nylon standoffs and four #6-32 screws in the kit. It has been 50 years since the nuclear disaster.
The sport of sprint racing is now a ruthless battle between armed cars. These races take place on tracks built in the ruins of the dangerous nuclear zone known only as the BADLANDS. 2. Connect the JAMMA This is sprint racing gone BAD! 3. Turn on the power to the game. Check that the game PCB functions. If a video picture is not present, see Chapter 3. connector to the PCB. other) to finish first! Players shoot playfield targets for extra points and bonus missiles! Installing the Display Bezel Game Play Find the cardboard display bezel (part no. 047463-01). One Measure the size of the existing display bezel and cut the new display bezel to size, if necessary.
It’s all-out war on the track as players blast away at the drones (and each or two players can race at any time with Badlands’ buy-in and game continuation features. If a Installing the Product ID and FCC Label player loses to one of the drone cars, the player can put in another coin to continue on to the next heat and retain any custom car options he has acquired. Place the product ID label (part no. 038158-01) and FCC label (part no. 039450-01) on the back of the cabi- Each race has four laps. Players continue on to the next racing heat as long as they beat the drone car. net. Installing the Side Panel Decals Find the side panel decals.
Wet the left and right side panels of the cabinet with slightly soapy water. Then position the decals as shown in Figure 1-4. Remove any wrinkles in the artwork using a squeegee. Allow Badlands has eight unique track layouts set in eight different animated backgrounds that react to player shots and crashes. These backgrounds change with the level of difficulty. The backgrounds are: @ the sides to dry. Installing the Attraction Assembly Find the attraction shield and the attraction film. Using the existing shield as a template, cut the shield and film to size, if necessary. Install them on the cabinet as , shown in Figure 1-4. m Use the self-test to check the operation of the game.
The Desert—the mountain rumbles and falls onto the track. m@ The Freeway—make your own shortcuts through the diner and gas station. m= The Volcano—lava spills down upon the track. The Junkyard—power explode on impact. Testing After Power-Up Refer to Chapter 2 for information about the self-test. The City—watch out for falling power lines and the water tower that crashes, spilling water on the track that slows you down. m lines fall and old cars The Military Base—cannons explode. fire and missiles 1-9