Atari Games Badlands Universal Kit — Atari Badlands Universal Kit Installation Instructions Manual PDF

Badlands Universal Kit Installation serial number, part number and description missing or damaged parts, and date received. of the Drill the holes in the cabinet with a 5/16-inch drill bit. Preparing the Cabinet for the Kit Installation NOTE if you have a cabinet with a recessed base, put the pedal template higher so you will not drill into the gussets in the corners. 1. Turn off power to the game. 2. Remove the following from the cabinet: You will also have BH Old PCB(s). through the cabinet floor to feed the pedal 7. @ Control panel decals,labels, and controls. m Side decals, graphics and adhesive. If the cabinet sides are damaged, repair them before putting on the new decals.

display bezel, To set up the Badlands control panel you need the following parts from the kit: attraction Black metal cover plate Control panel decal Two red and two blue buttons Four start/fire button collars Installing the Kit Parts are shown Feed the pedal harnesses through the center holes. Insert the 1 1/2-inch-long carriage bolts from the outside. Install the flat washers and lock nuts. Installing the Control Panel Wipe down and vacuum the cabinet. Paint the cabinet, if required. The kit parts Figure 1-4. holes wires into the cabinet. m@ Game harness if it is not Japan Amusement Machinery Manufacturers Association QAMMA)compatible. m Video display shield, shield, and marquee.

to drill two more installed on a cabinet Two steering assemblies in Two steering assembly mounting plates Six #10-24 x 1-inch-long carriage bolts, flat washers, and lock nuts Installing the Pedal Six To install the pedals, you need a copy of the pedal installation template at the end of this chapter and the following parts from the kit: Lay the black metal cover plate over the bare con- holes on the control panel. Screw two buttons in the two center holes. See Figure 1-3.

(If your control panel does not have the two center button holes in the correct position, just center the metal cover plate on the control panel.) Eight #10-24 x 1/2-inch-long pan-head screws, internal lock washers, and lock nuts Eight 1/4-20 x 1 1/2-inch-long carriage bolls, flat washers and lock nuts. Take a pedal apart by removing the set screws on the sides of the hinge. Take out the hinge pin. Take the pedal top off. Clamp the cover plate to the control three C-clamps. 4. 5. Cut the copy of the pedal installation template apart. Put the pieces on the the cabinet according to the dimensions shown in Figure 1-2 and on the template. “ Put a drop of oil on the hinge pin.

Reassemble the Put the other pedal on its bracket. panel with Drill six mounting holes for the cover plate through the control panel using a 3/16-inch drill bit. Use the #10-24 pan-head screws to attach pedal bottom to the bracket. (See Figure 1-1.) Install the lock washers and lock nuts. Put the ground wire lug between a lock washer and a lock nut on one of these screws. 4. and lock nuts. trol panel. Line up the two center button holes on the metal cover plate with the two center button The pedals and pedal brackets pedal. #1/4 flat washers t Install enough of the carriage bolts and lock nuts in the mounting holes to hold the cover plate in place.

Using the cover plate as a template, cut the holes for the outer buttons with the 1 3/16-inch hole cutter. Drill three mounting holes for each steering assembly using a 5/16-inch drill bit. You may also need to drill holes for the steering harnesses. Take the metal cover plate off the control panel. With the cover plate off, install the control panel 1-3