Test Control unit (processor run-on) Flash code: 3x long, 8x short Fault indication: Fault is not indicated by the EDC indicator lamp Fault path: Control unit Processor run-on did not take place Effect of fault: No direct effect Function: Every time the engine is turned off, run-on takes place automatically for the purpose of checking the various processor functions Possible cause: Control unit faulty, main relay faulty, battery voltage switched off before “igni- tion” off. Test precondition: EDC control unit disconnected Socket box connected Other possible causes Engine was shut down via battery + (e.g. by disconnecting the battery or actuating the main fuse switch) Power supply fault (e.g.
undervoltage, main relay faulty, loose contact) 50 Test Measurement Corrective measures Control unit Test same as for undervoltage (page 40) and main relay (page 45) – Switch ignition on and off again, clear fault code – Same as pages 40 and 45 – Replace control unit (only disconnect the control unit once the current is switched off)