Operation 3.3. Operation Picking up the load 1. Drive slowly up to the load to be picked up. Danger of accidents! If the load does not lie in centre of grav ity, the stability of the machine is impaired. Drive under the load until it is touching the fork back of the forklift truck attachment. 2. Drive so far under the load until it touches the fork back of the forklift truck attachment. 3. Tip in slightly the forklift truck attachment so that the load can not fall down. 4. Lower the boom to its transport position. The two red arrows of the transport position marking on the bucket cylinder will then be lined up next to each other. 5.
Then lift the load to the appropriate height only shortly before you reach the stacking surface. Raise the load a little higher than necessary. 6. Set the load surface slowly and from above onto the stacking. 7. Slowly lower the boom so far that you can pull out the fork tines below the load. 8. Make sure that nobody is behind the machine and drive off backwards from the stacking surface. WA90-5 – VEAM270100 3-65 WARNING WARNING