3.3. Operation Operation Removing the multi-purpose bucket 1. Lower the multi-purpose bucket onto level ground. 2. Switch off the engine. 3. Set the control lever for special equipment first to position ‘1’ and then to position ‘2’ (figure G0065018.eps). 4. Turn the change-over lever for the supplementary control cir cuit to position ‘2’ until it reaches the limit stop (figure 75_160). 2 5. Disconnect the multi-purpose bucket hoses from the quick couplings. 6. Restart the engine. 1 7. Unlock the quick-change unit by setting the control lever for special equipment into position ‘1’ (fig. G0065018.eps). 75_160 8. Set the quick-change unit into the dumping position ‘A’ (fig.
G0065021.eps) using the multi-function lever, until the quick- change unit is unhooked of the work unit's pickup hooks. 9. Make sure that nobody is behind the machine and drive the machine away from the work unit. Level indicator for the bucket On both sides of the bucket the upper edges (see arrow) are arranged in parallel to the bucket edge and can be used as a level indicator for the bucket. You can recognise the position of the cutting edge of the bucket from the driver’s seat with the help of the level indicators. 3-74 WA90-5 – VEAM270100