4.1. Towing the machine Troubleshooting After towing: 1. Tip up the driver's cab. Proceed as described in the Safety chapter, under ""Tipping up the driver's cab" on page 2-22". 2. After the towing is finished, loosen the lock nut (4) and unscrew the threaded pin (5) counter-clockwise until it stops. Hold the valve (3) with a wrench and retighten the lock nut (4). Perform this task on both valves. 3. Put the protective caps (2) on the valves. 4. Tip down the driver's cab. Proceed as described in the Safety chapter, under ""Tipping down the driver's cab" on page 2-25". NOTE When the engine is switched off, the power-assisted steering is not operational, i.e.
you have to apply much more force to steer the machine. If you lift up the rear axle of the machine with a lorry-mounted crane, you can tow off the machine over longer distances and at speeds exceeding 2 km/h. Before you do this you must, however, remove the drive shaft of the front axle. In addition, secure the articulated steering with the locking bar, in the same way as it is required for transport of the machine on a low bed loader or by train. 4-4 WA90-5 – VEAM270100