Technical data 6.2. Noise emission levels 6.2. Noise emission levels Two plates indicating the machine noise level are attached. In accordance with ISO 6396 the value for the sound pressure level is L pA = dB/A In accordance with EC Directive 2000/14/EG the value for the sound power level is L WA = 99 dB/A No alterations may be made to the machine which could have an influence on the noise emission level. 6.3. Vibration level When used for its intended purpose, levels of vibration for the earthworking machine transmitted from the operator's seat are lower or equal to the test vibrations for the relative machinery class in compliance with ISO 7096.
The actual accelaration value of the upper limbs is less than 2.5 m/sІ. The actual acceleration value for the body is less than 0.76 m/sІ. These values were determined using a representative machine and with the help of the measurement procedures that are defined in the directives ISO 2631/1 and ISO 5349. 6.4. Limit values for slopes Maximum slope angle for machine operation If operating the machine on a slope, its angle must not exceed 35° uphill, downhill or sideways. If you angle the machine at more than 35° during operation, the motor, transmission, hydraulic sys tem or axles, will not be supplied with sufficient oil and can be damaged.
A uphill 30° B downhill 30° C sideways 30° 75_046 WA90-5 – VEAM270100 6-3