Operation 3.3 Operation Check coolant level, add coolant ! Do not open the radiator cap unless necessary. When checking the coolant, always wait for the engine to cool down and check the sub tank. ! Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to check the coolant level in this condition, there is a hazard of burns. Wait for the tem- perature to go down, then turn the cap slowly to release the pressure before removing it. When adding coolant, use the step and handrail provided, and support your body securely. 1. Open side door of the engine hood on the right side of the machine. 2.
Check that the coolant level is between the FULL and LOW range on sub-tank (1). If the coolant level is low, add coolant through the water filler port of sub-tank (1) to the FULL line. 3. After adding coolant, tighten the cap securely. 1 GK038068 4. If sub tank (1) is empty, check for coolant leakage, then check the coolant level in the radiator. If the coolant level is low, add coolant to the radiator, then add coolant to sub tank (1). If the volume of coolant added is more than usual, check for possible leakage. Confirm that there is no oil in the coolant. WA380-6H – VEAM440100 3-85 WARNING WARNING CAUTION CAUTION GK032181