Komatsu — Clean radiator fins and cooler fins

4.9 Service procedure Maintenance When required Clean radiator fins and cooler fins ! Never open the engine side cover when the engine is run- ning. Stop the engine completely before starting the cleaning operation. ! If compressed air, pressurized water, or steam hits your body directly, or causes dirt to fly, it may lead to personal injury. Always wear safety glasses, dust mask, or other pro- tective equipment. Clean the radiator if mud or dirt is stuck to it. Clean fins by rotating cooling fan in reverse NOTE When rotating the fan in reverse, be careful of flying dust and take steps to prevent cloth or other objects from getting caught in the fan.

Dust may rise, so check that there is no one in the surrounding area when rotating the fan in reverse. On jobsites where the dust accumulates on to the radiator or cooler, turn cooling fan reverse rotation switch (1) ON to rotate the fan in the reverse direction and blow out the dust stuck to the radiator or cooler. This can be used to extend the cleaning inter- val. GK038086 1 Manual fan reversing method NOTE ! Never rotate the fan in reverse by hand when carrying out the operation. ! Before operating the fan reverse rotation switch, run the engine at low idling. 1. Set the directional lever to the Neutral position. 2.

Set the parking brake switch to the ON position to apply the parking brake. a 3. Run the engine at low idling. 4. Press position (a) (manual reverse rotation ON) of cooling fan reverse rotation switch (1). GK038035 WA380-6H – VEAM440100 4-43 WARNING WARNING