4.9 Service procedure Maintenance Every 500 hours service 4. Using a filter wrench, turn filter cartridge (1) counterclock- wise to remove it. 5. Take water separator cup (2) installed to the bottom of the cartridge and turn it to the left to remove it. (This cup is used again. If it is damaged, replace it with a new part.) 6. Install cup (2) to the bottom of the new fuel pre-filter car- tridge. 1 When doing this, always replace the seal ring with a new part. GK038116 Tightening torque for cup: 10 Nm When replacing the seal ring, coat the surface with clean fuel before installing it. 7. Check that drain plug (3) at the bottom of water separator cup (2) is tightened securely.
2 Tightening torque: 0.2 - 0.45 Nm 3 GK038117 8. Clean the filter holder. B NOTE When filling the filter cartridge with fuel, carry out the filling oper- ation with cap (A) fitted. Cap (A) acts to prevent the entry of dirt or dust into the filter car- tridge. A 9. Fill the filter cartridge with clean fuel through the 8 small holes (B) in the new filter cartridge. 10. Coat the packing surface of the filter cartridge with oil. GK043095 11. Remove filter cartridge cap (A) and install to the filter holder. 12. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up 1/2 to 3/4 of a turn.
If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter car- tridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. WA380-6H – VEAM440100 4-69