Komatsu — Replace fuel filter cartridge

4.9 Service procedure Every 1000 hours service Maintenance NOTE ! Do not fill the filter cartridge with fuel. ! Cap (A) is installed to prevent dirt from entering the inside of the filter cartridge. 5. Coat the packing surface of the filter cartridge with oil. 6. Remove filter cartridge cap (A) and install to the filter holder. A 7. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter car- tridge is too loose, fuel will also leak from the packing, so always tighten the correct amount.

GK038118 8. After completing replacement of fuel filter cartridge (1), bleed the air from the system. 9. After completing the air bleeding, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage, check the tightening condition of the fil- ter cartridge. If there is still fuel leakage, repeat Steps 1 - 3 to remove the filter cartridge, then check the packing surface for damage or embedded dirt. If any damage or embedded dirt is found, replace the car- tridge with a new part and repeat Steps 4 - 8 to install it Procedure for bleeding air 1. Fill the fuel tank with fuel. 2. Open the engine side cover on the right side of the chassis. 3.

Loosen and pull out feed pump knob (1) and move it forward and backward. The plug on the fuel filter head does not need to be removed. 1 Keep moving knob (1) until it becomes heavy. GK038116 4. After bleeding air, push in and tighten knob (1). 4-72 WA380-6H – VEAM440100