Komatsu — 5.4 Limit values for slopes

Technical Data 5.4 Limit values for slopes 5.4 Limit values for slopes Maximum slope angle for machine operation If operating the machine on a slope, its angle must not exceed 25° uphill, 35° downhill or 16° sideways. If you angle the machine at more than 35° during operation, the motor, transmis- sion, hydraulic system or axles, will not be supplied with suffi- cient oil and can be damaged. A uphill 25° B downhill 35° C sideways 16° Tipping angle, theoretically The tipping angle is a calculated value. This states the angle at which the machine at rest can stand on a slope without tipping over.

You must not work with the machine at these angles as the motor, transmission, hydraulic system or axles, will not be sup- plied with sufficient oil and can be damaged. The specified angle refers to the transport position. The angle changes if you raise or lower the work unit. A uphill with operating load uphill without operating load 61.9° 52.4° B downhill with operating load downhill without operating load 36.0° 54.0° C lateral with operating load lateral without operating load 40.4° 41.2° GK100372 WA380-6H – VEAM440100 5-7