John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Operating the Machine CONTROL LEVER PATTERN CONVERSION To change your machine pilot control levers from the standard pattern to a John Deere pattern: 1. Lower bucket to the ground. Turn auto-idle switch off. 2. Run engine with engine rpm dial at 1/3 position without load for 2 minutes. 3. Move engine rpm dial to slow idle position, and turn key switch to OFF to stop engine. Remove key from switch. 4. Move pilot control shut-off lever to locked position. CAUTION: High pressure release of oil from pressurized system can cause serious burns or penetrating injury. The hydraulic tank is pressurized. Do not remove vent plug. Release pressure by loosening vent plug. 5.

Loosen vent plug to relieve air pressure. 6. Open door on storage compartment behind cab. 7. Remove cover above flow regulator valve. Continued on next page TX,35,DH5038 –19–06JUN96–1/2 7-3