John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Operating the Machine CONTROL LEVERS JOHN DEERE PATTERN CAUTION: Avoid serious crushing injury from boom. Never place any part of body beyond window frame. It could be crushed by the boom if boom control lever is accidentally bumped or otherwise engaged. If window is missing or broken, replace immediately. T7364AT –UN–10OCT90 Prevent possible injury from unexpected machine movement. Make sure you know the location and function of each control before operating. Never place any part of the body beyond the window frame. Replace missing or broken windows immediately. A conversion kit is available from your John Deere dealer to change your controls to the pattern shown.

IMPORTANT: Prevent possible machine damage. When digging, avoid contacting tracks with boom cylinders or bucket. When digging over the end of the tracks, propel motors should be at the rear to minimize chain and sprocket wear and to maximize machine stability and lift capacity. NOTE: With this control pattern, functions must correspond to the black-on-yellow labels located on the control console. T6811AD –UN–18OCT88 Do not contact tracks with boom cylinders or bucket. When digging over the end of tracks, propel motors should be at the rear of machine. When a lever is released, it will return to neutral. The machine will remain positioned.

A—Boom Down B—Boom Up C—Swing Left D—Swing Right E—Arm Out F—Arm In G—Bucket Load H—Bucket Dump TX,35,DH5512 –19–13AUG91–1/1 7-5