TM 5-3805-280-10 Operating the Machine MOVING MACHINE OFF AN EMBANKMENT 1. To move machine over edge of embankment, position bucket with flat surface resting on ground. Angle (A) of arm to boom should be 90 ° . Bucket must be on ground before machine begins to tip. T7527DJ –UN–05JUN91 TX,35,DH5639 –19–26MAR97–1/3 IMPORTANT: To prevent machine damage, do not allow machine to impact ground with bucket absorbing force of the fall. 2. As machine moves forward, raise the boom and retract arm until front of tracks reaches the lower ground level. 3. Raise bucket off the ground. Rotate upperstructure T7527DK –UN–05JUN91 180 ° . TX,35,DH5639 –19–26MAR97–2/3 4.
Position bucket on ground with flat surface of bucket resting on ground. Angle (A) of arm to boom should be 90 ° . 5. Lower boom slightly and propel machine towards lower level as the arm is extended. T7527DL –UN–05JUN91 6. When tracks clear embankment, raise boom to lower undercarriage on lower ground level. 7. To move machine onto an embankment, reverse procedure. TX,35,DH5639 –19–26MAR97–3/3 7-14