John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 DRILLING POSITION FOR DRILLING Do not over reach. Position base of mast over top of hole.. Place mast base on ground slowly. Do not jack machine off ground. Do not re–position boom or mast whilst resting on ground. START UP DRILLING Check engine R.P.M mode setting. Start compressor. Close centralizer. Dust hood up. START DRILLING Flush air to collar position and dust collector on. Rotation only feed bit to just above ground. Move drill lever to “AUTO” position. Depress button / Flick feed lever forward and stop several times till bit travels without deflec- tion.

If not straight start new hole With bit straight hold lever forward and but- ton depressed to complete collaring to required depth. Use water if required but dust collector must be off (if machine is so equipped). Move feed up and down the collar with air off to solidify wall of hole. 7-51