John Deere 230LCR, 230LCRD — CHAPTER 8

Transporting TM 5-3805-280-10 LOADING MACHINE ON A TRAILER WARNING: The M870 and M870A1 trailers may be used to haul/transport the John Deere Hydraulic Excavators (Model Numbers 230LCR and 230LCRD) providing the following precautions are adhered to: T7405BI –UN–29NOV90 Position the longitudinal centerline of the hydraulic excavator as near as possible over the longitudinal centerline of the trailer, i.e., overhang of the hydraulic excavator tracks to be equal on both left and right outriggers. An M870 or M870A1 trailer shall be limited to primary and secondary roads (paved and gravel) when hauling a hydraulic excavator.

The truck/tractor shall reduce its top speed by 50% when hauling an M870 or M870A1 trailer loaded with a hydraulic excavator. An M870 or M870A1 trailer loaded with a hydraulic excavator shall not be operated on roads with side slopes greater than 10%. 1. Keep trailer bed clean. 2. Put chocks against trailer wheels. 3. Use a ramp or loading dock. Ramps must be strong enough and have a low angle of 10—15 ° . CAUTION: Prevent possible injury from unexpected machine movement. Turn auto-idle switch off and turn H/P mode switch off when loading or unloading the machine. 4. Turn auto-idle switch off and turn H/P mode switch off. 5. Load and unload machine on a level surface. 6.

Drive machine onto ramps slowly. 7. The centerline of the machine should be over the centerline of the trailer. 8. Position bucket with flat surface resting on trailer. Angle (A) of arm to boom should be 90 ° . Continued on next page TX,40,DH5074 –19–01JUL96–1/2 8-1