John Deere 230LCR, 230LCRD — CHAPTER 9

Fuels and Lubricants TM 5-3805-280-10 DIESEL FUEL Consult your local fuel distributor for properties of the diesel fuel available in your area. Fuel Lubricity should pass a minimum of 3100 gram load level as measured by the SL BOCLE scuffing test. Sulfur content: Sulfur content should not exceed 0.5% Sulfur content less than 0.05% is preferred. If diesel fuel with sulfur content greater than 0.5% sulfur content is used, reduce the service interval for engine oil and filter by 50%. DO NOT use diesel fuel with sulfur content greater than 1.0%. In general, diesel fuels are blended to satisfy the low temperature requirements of the geographical area in which they are marketed.

Diesel fuels specified to A-A-52557, EN 590 or ASTM D975 are recommended. In all cases, the fuel shall meet the following properties: Bio-diesel fuels with properties and meeting DIN 51606 or equivalent specifications may be used. Cetane Number 40 minimum. Cetane number greater than 50 is preferred, especially for temperatures below -20 ° C (-4 ° F) or elevations above 1500 m (5000 ft). Cold Filter Plugging Point (CFPP) below the expected low temperature OR Cloud Point at least 5 ° C (9 ° F) below the expected low temperature. Aviation fuel Grade JP-8 may be used. DO NOT mix used engine oil or any other type of lubricant with diesel fuel.

CED,OUOE020,2 –19–11FEB99–1/1 LUBRICITY OF DIESEL FUELS Diesel fuel must have adequate lubricity to ensure proper operation and durability of fuel injection system components. engine speed instability, hard starting, low power, and engine smoke. Diesel fuels for highway use in the United States and Canada now require sulfur content less than 0.05%. Diesel fuel in the European Union will require sulfur content less than 0.05% by 1 October 1996. Fuel lubricity should pass a minimum of 3100 gram load level as measured by the SL BOCLE scuffing test. A-A-52557, ASTM D975 and EN 590 specifications do not require fuels to pass a fuel lubricity test.

Experience shows that some low sulfur diesel fuels may have inadequate lubricity and their use may reduce performance in fuel injection systems due to inadequate lubrication of injection pump components. The lower concentration of aromatic compounds in these fuels also adversely affects injection pump seals and may result in leaks. If fuel of low or unknown lubricity is used, add John Deere PREMIUM DIESEL FUEL CONDITIONER or Inhibitor, Corrosion/Lubricity Improver, Fuel Soluble (MIL-PRF-25017) at the recommended concentration. John Deere PREMIUM DIESEL FUEL CONDITIONER is available in winter and summer formulas.

Consult your John Deere engine distributor or servicing dealer for more information. Use of low lubricity diesel fuels may also cause accelerated wear, injection nozzle erosion or corrosion, TX,45,JC1771 –19–08JAN97–1/1 9-1