TM 5-3805-280-10 Maintenance—Every 250 Hours CAUTION: High pressure release of fluids from pressurized system can cause serious burns. Wait for propel gearbox oil to cool. Keep body and face away from check plug. Gradually loosen check plug to release air to relieve pressure. 9. After propel gearbox has cooled, slowly loosen check plug (B) to release air to relieve pressure. 10. Remove check plug. Oil must be to bottom of hole. T7396CG –UN–18OCT90 11. If necessary, add oil until oil flows out of oil level check plug hole. (See Fuels and Lubricants chapter.) 12. Wrap threads of plug with sealing-type tape. Install plug. Tighten plug to 49 (36 lb-ft).
A—Fill Plug B—Check Plug C—Drain Plug D—Horizontal Centerline 13. Check second propel gearbox oil level. TX,75,DH5098 –19–08JUL96–2/2 CLEAN DUSTY PRIMARY ELEMENT 1. Tap element with the palm of your hand, NOT ON A HARD SURFACE. T47764 –UN–09NOV88 CAUTION: Prevent possible injury from flying chips if compressed air is more than 210 kPa (2.1 bar) (30 psi). Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. 2. If this does not remove dust, use compressed air under 210 kPa (2.1 bar) (30 psi). 3.
Direct air up and down the pleats from inside to outside. Be careful not to make a break in the element. 03T,55,MM11 –19–18NOV92–1/1 14-9