Maintenance—Every 500 Hours TM 5-3805-280-10 GREASE SWING BEARING CAUTION: Prevent possible injury from unexpected machine movement if controls are moved by another person. Lubricating swing bearing and rotating the upperstructure must be done by one person. Before you lubricate swing bearing, clear the area of all persons. T7869BM –UN–22OCT92 1. Park machine on a level surface. 2. Lower bucket to the ground. 3. Turn auto-idle switch off. IMPORTANT: Turbocharger may be damaged if engine is not properly shut down. 4. Run engine with engine rpm dial at 1/3 position without load for 2 minutes. 5. Move engine rpm dial to slow idle position. 6. Turn key switch to OFF. Remove key from switch. 7.
Attach a Not Operate’ tag on the right control lever. 8. Pull pilot control shut-off lever to locked position. 9. Lubricate swing bearing with ten shots of grease at both grease fittings. (See Fuels and Lubricants chapter.) 10. Start engine. Raise bucket several inches off the ground and turn upperstructure 45 degrees. 11. Repeat steps three times. NOTE: It is not necessary to start the engine the last time. TX,80,DH5099 –19–08JUL96–1/1 15-1