John Deere 230LCR, 230LCRD — CHAPTER 19

TM 5-3805-280-10 Maintenance intervals WHEN REQUIRED Drifter chain tension Hose tension The adjustment is carried out on the chain tighten- er A (see Figure). Generally speaking, the chains should not be too tight (the front chain vibrates abnor- mally during drilling) or too loose (the front chain lashes out against the feed box or the tightener strikes against the feed extension cylinder attach- ment). All the hoses should be tightened with the excep- tion of the drifter hoses (P1 and P2) which should sag slightly when they are not under pressure (the pres- sure tightens these hoses when in operation).

Chain replacement The guide should be put in toe hole drilling posi- tion, horizontal, to prevent cradles from sliding when the chains or the reel rope are dismounted. Change the chains when the tightener no lon- ger reaches their extension. Hose reel chain tension In the same way, the adjustment is carried out on the chain tightener B (see Figure). The cable should not sag. After chain (rope) replacement, move the drifter back to its rear end position. Verify the distance be- tween the drifter cradle and the hose reel cradle is 60 15 mm (2.4 .6 in) (see Figure). 19-3