John Deere 230LCR, 230LCRD — CHAPTER 20

TM 5-3805-280-10 Maintenance SERVICE RECOMMENDATIONS FOR INCH SERIES FOUR BOLT FLANGE FITTINGS T6890BB –UN–01MAR90 A—Sealing Surface B—Split Flange C—Pinched O-Ring D—Single Piece Flange 1. Clean sealing surfaces (A). Inspect. Scratches cause leaks. Roughness causes seal wear. Out-of-flat causes seal extrusion. If defects cannot be polished out, replace component. must be centrally located on port. Hand tighten cap screws to hold flange in place. Do not pinch O-ring. 5. Tighten one cap screw, then tighten the diagonally opposite cap screw. Tighten two remaining cap screws. Tighten all cap screws as specified in the chart below. 2.

Install O-ring (and backup washer if required) into groove using petroleum jelly to hold it in place. 3. Split flange: Loosely assemble split flange (B) DO NOT use air wrenches. DO NOT tighten one cap screw fully before tightening the others. DO NOT over tighten. halves. Make sure split is centrally located and perpendicular to port. Hand tighten cap screws to hold parts in place. Do not pinch O-ring (C). 4. Single piece flange (D): Place hydraulic line in center of flange and install cap screws. Flange Continued on next page 04T,90,K174 –19–01AUG94–1/2 20-26