TM 5-3805-280-10 Troubleshooting Symptom Problem Solution Low battery charge Recharge or replace batteries. Starter solenoid ’hold-in’ windings Go to your authorized dealer. open Starter Turns But Will Not Crank Starter pinion gear not engaging Go to your authorized dealer. Engine flywheel ring gear Pinion shift mechanism jammed or Go to your authorized dealer. malfunctioning Pinion gear teeth broken Go to your authorized dealer. Flywheel gear teeth broken Go to your authorized dealer. Engine Cranks Slowly Battery cables damaged or broken Inspect and replace cables. internally Battery or starter cable connections Clean and tighten connections.
loose or corroded Battery discharged or will not hold a Recharge or replace battery. charge Starter ’dragging’ Go to your authorized dealer. Low battery voltage Recharge or replace battery. Starter Continues To Run After Starter relay stuck Go to your authorized dealer. Engine Starts Starter solenoid stuck Go to your authorized dealer. Starter not disengaging Go to your authorized dealer. Key switch Go to your authorized dealer. Charging Indicator Light On, Loose or glazed alternator belt Check belt. Replace if glazed. Engine Running Engine rpm low Adjust rpm to specifications. Excessive electrical load from added Remove accessories or install higher accessories output alternator.
Continued on next page TX,100,DH5361 –19–19DEC96–3/6 22-10