TM 5-3805-280-10 Storage IMPORTANT: Prevent possible engine damage. During cold temperatures, check viscosity of engine oil on dipstick. If the oil appears waxy and/or jelly-like rather than liquid, DO NOT attempt to start engine. Use external heat source to warm the crankcase until oil appears fluid. T6181AU –UN–18OCT88 3. Check all fluid levels. If low, check for leaks and add oil as required. 4. Check belt. 5. Check condition of all hoses and connections. 6. Check electrolyte level. Charge and install battery. 7. Fill fuel tank. (See Fuels and Lubricants chapter.) 8. Start engine. Run engine at 1/2 speed for 5 minutes. Do not run at fast or slow idle. 9. Bleed fuel system.
If engine fails to start or runs poorly after starting, change fuel filter(s). Bleed fuel system again. CAUTION: Prevent possible injury from unexpected machine movement. Clear the area of all persons before running machine through the operation procedure. 10. Make sure that area is clear to allow for movement. Operate (cycle) boom, arm, and bucket functions for three complete cycles. 11. Operate the swing function for three complete revolutions in each direction. 12. Check condition of tracks. Check track sag. Continued on next page TX,105,FF,400 –19–06SEP94–2/4 23-4