STRUCTURE AND FUNCTION SWING MOTOR Outline This valve reduces the swing back generation in the swing body by the inertia of the swing body, the backlash and ngidity of the machinery system, and the compression of the hydraulic oil when the swing is stopped. This is effective in preventing spillage of the bad and reducing the cycle time when stopping the swing (the po- sitioning ability is good and it is possible to move swiftly to the next job). Operation 1 . When brake pressure is being generated at port MB a. Pressure MB passes through the notch and goes to chamber d , spool (5) pushes spring (6) according to the difterence in area D1 > D2 , moves to the left, and MB is connected to e. b.
When this happens, pressure MA is below the set pressure of spring (3>, 50 spool (2> d9es not move. For this reason, the pres- sure oil is closed by spool (2) and the brak- ing force is ensured. 2. Aftermotorstops a. The motor is reversed by the closing pres- sure generated at port MB . (1 st reversal> When this happens, reversal pressure is generated at port MA . Pressure MA goes to chamber a , so spool (2) pushes spring (3) and moves to the right, and MA is con- nected to B . At the same time, b is con- nected to f through the drili hole in spool (5), 50 the reversal pressure at port MA is bypassed to port T to prevent the 2nd re- versal. 10-96