Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM Function The following two functions are available to pro- vide the optimum matching under various work- ing conditions: a 2-stage relief function which increases the digging power, and a fine control mode function which improves the ease of fine control. LS control function The switching point (LS set differential pres- sure) for the pump discharge amount inside the LS valve is changed by changing the output pressure from the LS control EPC valve to the LS valve according to the engine speed and op- erating condition of the actuator.

Because of this, the timing for starting the dis- charge amount from the pump can be optimized, to give excellent ease of compound operation and fine control. Cut-off function For details of the operation, see CLSS. When the cut-off function is actuated, the PC- EPC current is increased to near the maximum value. In this way, the flow at relief is made smaller and the fuel consumption is reduced. Actuation conditions for cut-off function. When the front or rear pressure sensor is above 30.9 MPa (315 kg/cm 2 ) and the power max. or quick slow-down functions are not being actuated. Note: When traveling or when using the lifting op- eration mode, the cut-off is not actuated. 10-146