Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM Engine overheat prevention function This function protects the engine by lowering the pump load and engine speed to prevent the overheating when the engine coolant temperature has risen too high. This system is actuated in two stages. The first stage is when the coolant temperature is between 102°C and 105°C, and the second stage is when the coolant temperature is 105°C and above. Normal operation (Coolant temperature below 102°C) Actuation condition 1st stage (Coolant temperature between 102°C and 105°C) 2nd stage (Coolant temperature 105°C and above) 10-152 Normal operation Coolant temperature: Below 102°C Coolant temperature gauge:

Green range Actuation condition Actuation condition Cancel condition 1st stage Coolant temperature: Between 102°C and 105°C Coolant temperature gauge: Red range Working mode 81 kW (108 HP) Coolant temperature: Below 102°C Heavy-duty, general, finishing, breaker Flow 57% • When the above condition is met, the system re- turns to the con- dition before the overheat preven- tion function was actuated (auto- matic reset) Mode kept as it is, output reduced Lifting Lifting operation kept as it is Actuation condition Actuation condition Cancel condition 2nd stage Coolant temperature: 105°C and above Coolant temperature gauge: Red range Working mode In any mode Coolant temperature:

Below 102°C Fuel control dial: Return temporarily to low idling position Engine speed Low idling Monitor caution lamp Lights up • When the above condi- tions are met, the system return tot the condition before the overheat pre- vention function was ac- tuated (manual reset) Caution buzzer Sound