Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION HOW TO SET TELEPHONE NUMBER HOW TO SET TELEPHONE NUMBER The service contact telephone number may be changed by the following procedure. (i) Enter the telephone number change mode by keeping the time switch and the auto-decel switch pressed for 2.5 seconds. The display will change to show the current telephone number in the monitor panel memory (or ten zeros if no number is stored). Flashing (ii) The first two digits will flash. The first digit may be set by pressing the “travel speed up” button. The second digit may be set by pressing the “travel speed down” button. Note that pressing either button once will increase the respective digit by 1.

(iii) The next pair of numbers be adjusted by press- ing the time switch and the “working mode se- lect M arrow” button. Flashing 24 (time switch + ) Note: It is possible to move back to the pre- vious pair of digits by pressing the time switch and the “working mode select H arrow” button ( ). (iv) follow the procedure given in (ii) to change the third & fourth digits. Once these have been set the fifth and sixth digits may be selected the pro- cedure shown in (iii) above. Repeat this method until all the digits have been set successfully. (v) To store the new number and return to normal monitor display, keep the time switch and auto- decel buttons pressed for 2.5 seconds. 10-170