TESTING AND ADJUSTING STANDARD VALUE TABLE 20-15 Cate- gory Discharge amount of main piston pump (in H/O mode) Performance of hydraulic pump • Pump speed: At 2200 rpm, PC current 180 mA Test pump Discharge Standard value Judgement Average discharge pressure of for discharge standard lower Check point pressure pressure other pump amount limit (kg/cm2) (kg/cm2) (kg/cm2) Q (l /min) Q (l /min) As desired P1 P2 P1 + P2 See graph See graph 2 # As far as possible, bring pump discharge pressures P and P as close as possible to the average 1 2 pressure when measuring. The error is large near the point where the graph curves, so avoid measuring at this point.
# When measuring with the pump mounted on the machine, if it is impossible to set the engine speed to the specified speed with the fuel control dial, take the pump discharge amount and the engine speed at the point of measurement, and use them as a base for calculating the pump discharge amount at the specified speed. Check point Test pump discharge pressure (kg/cm2) Discharge pressure of other pump (kg/cm2) Average pressure (kg/cm2) Standard value for discharge amount Q (l /min) Judgement standard lower limit Q (l /min) As desired P1 P2 P1 + P2 2 See graph See graph