TESTING AND ADJUSTING STANDARD VALUE TABLE 20-20 Sys- tem Name of component Connector No. Inspection method Judgement table Measurement conditions Control system Governor, pump controller 2-stage relief solenoid C01 Measure voltage If the condition is as shown in the table be- low, it is normal. SWwhienngt rloavcekl siswoitpcehr aOteNd (insdoelepneonidde ntOlyN(s:o leHnoigidh 20-30V pOrNe,ssduivridee)d) Between ((120))- - Swing lock switch Whenleversand (6),(12) OpeFdFa ls(asroeleantoniedu trOalFF:
0-3V L(soowle nporeidsOsuFrFe,)merged) 1) Start engine 2) Insert T-adapter PC solenoid valve (default value) C02 Measure current If the condition is as shown in the table be- low, it is normal Between((87)) -- ((1187)) 515 ± 10900 m0A±80mA 1) Turn starting switch ON. 2) Turn fuel control dial to MAX positon 3) Turn prolix switch OFF. 4) All levers at neutral. LS-EPC solenoid valve (default value) C02 Measure current If the condition is as shown in the table be- low, it is normal • H/O mode Between(7)-(17) 900±80mA 1) Turn starting switch ON. 2) Turn fuel control dial to MAX position 3) All levers at neutral. L.H.
knob switch C03 Measure voltage If the condition is as shown in the table be- low, it is normal WhenswitchisON 20-28V Between (9)-GND WhenswitchisOFF 0-1V 1) Turn starting switch ON. 2) Insert T - adapter. S-NET C17 Measure voltage If the condition is as shown in the table be- low, it is normal Between(4),(12)-GND 4-8V 1) Turn starting switch ON. 2) Insert T - adapter No.
2 throttle signal Monitoring code 16 Engine speed If the condition is as shown in the table be- low, it is normal PC290 Active mode Approx 2300 H/O (working) Approx 2300 H/O (travelling) Approx 2400 G/O Approx 2100 F/O Approx 2100 L/O Approx 1750 B/O Approx 2100 Power Max Approx 2400 (H/O, G/O) Swift slow down Approx 1750 (H/O, G/O) 1) Start engine. 2) Set monitor- ing code to 10 or 16 (command value). 3) Operate working mode switch and L.H. knob switch.
Model selec- tion C17 - C02 Continuity If the condition is as shown in the table be- low, it is normal No continuity Betweenselection1 C17(5)-C02(11) Nocontinuity Betweenselection2 C17(13)-C02(11) Continuity Betweenselection3 C17(6)-C02(11) Continuity Betweenselection4 C17(14)-C02(11) CNoonctionnutiitnyuity Betweenselection5 C17(7)-C02(11) Nocontinuity 1) Turn starting switch OFF. 2) Disconnect connector. 3) Connect T - adapter to wiring har- ness end. SWwhienngt rloavcekl siswoitpcehr aOteNd (insdoelepneonidde ntOlyN(s:o leHnoigidh pOrNe,ssduivridee)d) Between ((120))- - (6),(12) 20-30V Swing lock switch Whenleversand OpeFdFa ls(asroeleantoniedu trOalFF:
L(soowle nporeidsOsuFrFe,)merged) 0-3V Between((87)) -- ((1187)) 515 ± 10900 m0A±80mA Between(7)-(17) 900±80mA WhenswitchisON Between (9)-GND 20-28V WhenswitchisOFF 0-1V Between(4),(12)-GND 4-8V PC290 Active mode Approx 2300 H/O (working) Approx 2300 H/O (travelling) Approx 2400 G/O Approx 2100 F/O Approx 2100 L/O Approx 1750 B/O Approx 2100 Power Max (H/O, G/O) Approx 2400 Swift slow down (H/O, G/O) Approx 1750 Betweenselection1 C17(5)-C02(11) No continuity Nocontinuity Betweenselection2 C17(13)-C02(11) Continuity Betweenselection3 C17(6)-C02(11) Continuity Betweenselection4 C17(14)-C02(11) CNoonctionnutiitnyuity Betweenselection5 C17(7)-C02(11) Nocontinuity