Komatsu — eebm001902 a3.pdf

TESTING AND ADJUSTING ADJUSTING VALVE CLEARANCE ADJUSTING VALVE CLEARANCE 1. Remove the cylinder head cover. 2. Using cranking tool Q , rotate the crankshaft in the nor- mal direction until timing pin (1) enters the hole in the gear. # This position is the No. 1 cylinder compression top dead center. 3. When No. 1 cylinder is at compression top dead center, adjust the valves marked G . Next, rotate the crankshaft one turn (360°) in the normal direction and adjust the valve clearance of the remaining valves marked G . # Make match marks on the crankshaft pulley or damper, then rotate 360°. 4.

To adjust the valve clearance, loosen locknut (6), then insert feeler gauge F between rocker lever (3) and valve stem (4), and turn adjustment screw (5) until the clearance is a sliding fit. Then tighten locknut (6) to hold the adjustment screw in position. Lock nut: 44.1 ± 4.9 Nm (4.5 ± 0.5 kgm) # After adjusting No. 1 cylinder at compression top dead center, it is also possible to turn the crank-shaft 180° each time and adjust the valve of each cylinder accord- ing to the firing order. Firing order: 1 - 5 - 3 - 6 - 2 - 4 # There is no timing mark on the front pulley, so set to compression top dead center as follows; a. If the firing order is followed, the next cylinder after No.

1 cylinder is No. 5 cylinder, so watch the movement of the No. 2 cylinder valves and rotate in the normal direction. b. When the clearance of both the intake and ex- haust valves of the No. 2 cylinder is 0, the No. 5 cylinder is at compression top dead center. (For the No. 3 cylinder, watch the movements of the No. 4 cylinder valves). 20-27